Care
Water resistance (IP67, IP68): what it means and why it fades
Short version
- Read the digits separately: 6 = no dust gets in at all, 8 = survives immersion deeper than 1 metre.
- The test uses still, fresh water on a new, motionless phone — the sea, the pool, soap and steam are outside it.
- The same IP68 means different depths per maker: 1.5 m at Samsung, up to 6 m on iPhone — check your model's spec sheet.
- Sealing fades on its own over time, and any repair that opens the phone destroys it — afterwards it's re-sealed, not re-certified.
- Liquid damage is never covered by warranty — not by Apple, Samsung or Google.
How to read the IP code
IP stands for “Ingress Protection” — protection against things getting in — defined by the international standard IEC 60529. The two digits after the letters measure different things: the first is about dust and solid objects, the second about water.
IP
Ingress Protection (IEC 60529)
First digit
dust and solid objects, 0–6
Second digit
water, 0–9
IP68
dust-tight + immersion beyond 1 m
X instead of a digit
not tested for that
6 is the top solids level: not even the finest dust gets in. For water, 7 means 30 minutes submerged at up to 1 metre deep, 8 means continuous immersion under conditions set by the maker — tougher than 7 — and 9, showing up on a few recent phones rated IP69, covers high-pressure jets of hot water. An X means the product was never tested on that count: Samsung's foldables carry IPX8 or IP48 — they resist water like an IP68, but for dust they're either unrated or only tested against objects larger than 1 mm.
| Rating | The lab test | In real life |
|---|---|---|
| IP54 | Splashes from any direction; limited dust ingress | Rain and accidental splashes — not a drop in water |
| IP67 | 30 minutes at max 1 m depth, still fresh water | Dropped in the sink or toilet and fished out fast |
| IP68 | Beyond 1 m, at least 30 minutes; the maker picks the depth | A short accidental dip — not water sports |
| IPX8 / IP48 | Same water test; no dust test, or only for objects over 1 mm | Foldables — water is fine, sand stays a risk |
| IP69 | Jets of water at roughly 80 °C under high pressure | Survives jet washing, but isn't a diving phone |
What the test covers — and what it leaves out
The test conditions are far gentler than an afternoon at the pool. Samsung describes it plainly: the phone is submerged in fresh water, at 1.5 m, for 30 minutes, left completely still. The water sits near the device's own temperature — Oppo specifies a difference of at most 5 °C — and the phone is new and factory-sealed.
At the same IP68 rating, the depth differs between makers because the standard lets each one choose it, along with the duration. Apple states 6 m for iPhone 12 and later, 4 m for iPhone 11 Pro and 2 m for iPhone 11 and XS, while iPhone 7, 8, X, XR and SE (2nd and 3rd generation) stay at IP67 — 1 m. Samsung sits at 1.5 m for IPX8/IP68, and some Xiaomi models declare as much as 3 m. “IP68” alone doesn't say how deep — your model's spec sheet does.
- Sea water — salt corrodes the contacts and isn't in the test.
- Pool water — chlorine and water-treatment chemicals attack the gaskets.
- Soap, shampoo, sunscreen, perfume — Apple and Samsung name them on their avoid lists.
- Steam — saunas or a steamy bathroom: vapour reaches places liquid water can't.
- Pressurised water — showers, jacuzzis, jet skis: a jet hits the seals far harder than still water in a tank.
- Moving water — the test uses a motionless phone; waves and your arm sweeping through water add pressure.
Note· The unspoken condition: intact and fully closed
3D phone. Highlighted parts: SIM tray, charging port, loudspeaker.
Why resistance fades over time
A sealed phone isn't a welded case: the screen and back glass are glued to the frame with adhesive strips under a millimetre thick, and the SIM tray, buttons and speaker have fine gaskets and membranes. The same adhesive keeps the phone in one piece and keeps water out.
Adhesive and rubber age: heat (a phone left in a car in summer), hot–cold cycles, sweat and chemicals dry them out and weaken them. And every drop or bend, even with no visible mark, warps the frame a little and tears micro-patches of glue. The makers say it themselves: “splash, water, and dust resistance are not permanent conditions and resistance might decrease as a result of normal wear” — Apple. Xiaomi adds that ingress protection “might deteriorate from daily wear and tear, physical damage and/or disassembly needed in case of repair”.
3D phone. Highlighted parts: screen adhesive, back cover adhesive.
Note· Nobody can tell you how sealed it is today
After a repair: re-sealed, not re-certified
Any repair that opens the phone — a screen replacement, a battery swap or a back glass replacement — cuts the factory adhesive strip. From the moment it's opened, the original sealing no longer exists.
A careful shop cleans all the old adhesive off the frame and fits a new, model-specific gasket pressed into place. What nobody outside the factory can do is re-run the phone through the certification tank — so the honest answer is “we re-sealed the phone”, not “it's IP68 again”. Even after an authorised repair, treat it as less resistant than before.
Warning· After it's been opened, keep it out of water
The warranty doesn't cover liquid
Every maker excludes liquid damage, even on IP68 phones. Apple puts it in writing: “Liquid damage is not covered under warranty, but you might have rights under consumer law.” Google is equally blunt for Pixel: damage from accidents, including water, isn't covered. Samsung excludes from every warranty products that show traces of contact with liquids, and Xiaomi and Oppo say the same in product-page footnotes.
The phone even carries witnesses: on iPhones with a SIM tray there's a small liquid contact indicator inside the tray channel — normally white-silver, it turns red after exposure — and other brands have similar stickers on the board that a technician reads in seconds. Your concrete rights in Romania are explained in Warranty and repair rights.
Sensible use near water
The right way to think about it: IP68 is accident insurance — like an airbag — not an invitation to go diving. It gets your phone out of the sink or toilet without drama, but it doesn't belong in the pool for underwater filming.
Do
- Wipe the phone well after rain or splashes and let it dry before charging.
- Push the SIM tray fully back after removing it — it's part of the seal.
- Keep it away from steam: not in the bathroom while you shower, not in the sauna.
- By the pool or shower, listen on a Bluetooth speaker — that's Google's own advice.
Don't
- Don't film underwater “because it's IP68” — pool chlorine and sea salt aren't in the test.
- Don't take it in the shower or rinse it under a jet — pressure isn't covered by the rating.
- Don't charge it while wet — the liquid alert exists precisely for that.
- Don't assume it's as sealed after two or three years, or after a repair.
And if it got wet anyway: take it out, power it off and let it dry — the exact steps, minute by minute, are in Phone dropped in water: the first 10 minutes. A liquid-in-port alert means unplug the cable right away, not plug it back in.
Disconnect the charging cable immediately.
Phone screen: Liquid Detected in USB-C Connector. Disconnect the charging cable immediately.
Connection: The wet phone via not while wet (broken) → The charger.
Frequently asked questions
Can I shower with my phone if it's IP68?
Can I take photos or film underwater with it?
Why does one phone say IP68 at 1.5 m and another IP68 at 6 m?
What do IPX8 and IP48 mean?
Is my phone still sealed after a screen replacement?
If water gets inside, does the warranty cover it?
Does IP68 protect against spilled beer, coffee or juice?
Does your phone look different, or is something missing here?
Menus and buttons differ from model to model and change with updates. If these steps do not match your phone or you cannot find what you need, tell us your model and what you see on the screen: we will answer you and update the guide.
Checked against
- Apple — Despre rezistența la stropire, apă și praf a iPhone
- Apple — Dacă vezi alerta de detectare a lichidului pe iPhone
- Samsung — Rezistența la apă a telefoanelor Galaxy
- Samsung — Informații despre garanție (excluderi)
- Google — Help prevent water damage to your Pixel phone
- Oppo — A6: IP68/IP69 test conditions
- Xiaomi — Xiaomi 15T Pro specifications and water-resistance notes
- Apple — Indicatorul de contact cu lichid (LCI) al iPhone
Related guides
Phone dropped in water: what to do in the first 10 minutes
First aid for a wet phone: power it off, dry it the right way and skip the mistakes that kill it.
10 min · Anyone can do it
Liquid damage: what a repair shop actually does
What a liquid-damage repair looks like on the bench: the stages, what decides the odds, and why 'it works, so it's fine' is a trap.
10 min · Better in a service
Screen replacement: what is actually done, how long it takes, what can go wrong
The real stages of a screen swap, what sets the price and the risks a careful shop prevents.
10 min · Better in a service
Cracked back glass and camera glass: what gets replaced
What actually gets replaced when the back is cracked, why the camera glass is a small part and what's left of the water seal.
10 min · Better in a service
Warranty and your rights on repairs in Romania
Two years of rights against the seller, free repair within 15 days, and what to do when they refuse — the rules, in short.
10 min · Anyone can do it
Dropped the phone in water?
Power it off and follow the first-aid steps in the dedicated guide — and if it stayed under for a while or won't start, bring it in for a [diagnostic at the shop](/service).